Intro to Fab Week 4 – Enclosure

Tools Needed   Utility Knife Paper Cardboard Glue Ruler Scissor Make the Enclosure       I just grabbed a cardboard and made an enclosure out of it. For the electronic part, I integrated an Arduino module which allowed you to change the brightness of two LEDs on the front panel with a potentiometer. I…

Intro to Fab Week 3 – Laser Cutters

Finally laser cutters! Precision come back to life! For assignment of the week, I decided to make a box with laser-cut dog patterns. It was not difficult and the tools I used were: 3 mm Ply Wood Board Illustrator Laser Cutter Wood Glue Draw & Print After I sketched out the blueprint, I started to…

Intro to Fab Week 2 – Times PI

This week’s assignment is about repetition and I make 5 squares chained on a dowel. I used the following to complete the assignment: Sander Wire stripper Knife Drill Problems I didn’t intend to do the simple square at first but five wood-copters. I used five wood blocks and tried to use the utility knife to…

ICM Week 11 – Final Project Proposal

Final Project in One Sentence A 2D side-scroller where you try to get to ITP on a cold winter day. Inspiration I love playinggames and stuff and always want to make one, so I decided to make a 2D side-scroller game for my final project. With my limited knowledge of programming, I try to make…

Animation Week 1 – ITP Halloween Arena

Wooh! The assignment this week is to make a stop motion video! Actually, I just finished Lego Movie: Batman a few days ago and it was great. The charm of stop-motion is that you can do a lot of amazing effects with it. Inspiration The project was influenced by the movie Captain America: Civil War, where two…